No products
The PH-4 hex wrench is made of hardened steel with a handle. It has an ergonomic "P" handle made of nylon and a Bondhus Balldriver tip that allows you to work with screws in hard-to-reach places.
The PH-6 hex wrench is made of hardened steel with a handle. It has an ergonomic "P" handle made of nylon and a Bondhus Balldriver tip that allows you to work with screws in hard-to-reach places.
The PH-8 hex wrench is made of hardened steel with a handle. It has an ergonomic "P" handle made of nylon and a Bondhus Balldriver tip that allows you to work with screws in hard-to-reach places.
The PH-10 hex wrench is made of hardened steel with a handle. It has an ergonomic "P" handle made of nylon and a Bondhus Balldriver tip that allows you to work with screws in hard-to-reach places.
The DH-1 slides into rear dropouts and replaces the rear wheel for chain cleaning and transport.
Designed for 12 spline 23.4mm diameter tool fittings - the most common tool fitting found on 7-12 speed cassette lockrings Shimano®, SRAM® (including 1x), SunRace®, SunTour®, Chris King®, and can also be found on some disc brake lockrings and Rock Shox® suspension fork top caps - Pike®, Lyrik™, SID®.
Removes four-notch freewheels from flip-flop BMX hubs with 30 x 1mm threads.The FR-8 has four notches approximately 25mm across measured inside to inside.
This combination chain whip and freewheel / lockring remover wrench is heat treated to prevent bending and flexing, with a molded handle for comfort.
Compatible with all 5-speed to 12-speed bicycle chains* including SRAM® eTap® AXS® and Shimano® XTR® 12-speed.
CM-5, CM-5.2, and CM-5.3 Cyclone™ Chain Scrubber brushes are replaceable.
The UK-1 is a combination of aluminum and stainless steel and uses readily available hardware store utility knife blades.
High quality scissors with sturdy, stainless steel blades and a dual density grip.